Advertisement
Flush Mount (4363L)
Please refer to the dimensional drawing located in the
resource section of the product page on elotouch.com.
1. Install included sealing foam around perimeter of
touchmonitor.
a. Peel back 2-3" of release liner from foam seal.
b. Align exposed end of foam seal with black mylar on
touchmonitor.
c. Gently peel back additional release liner as tape is
pressed into place.
d. Foam seal should not extend off of the edge of black
mylar.
2. Attach bracket "A" to touchmonitor with 2x M4 hex
screws (included), 2 brackets on each side of the
display (total 8 brackets).
3. Attach bracket "C" to interior side of enclosure per
dimensional drawing, 2 brackets on each side of the
display (total 8 brackets).
Black mylar
Enclosure
(inside view)
Bracket C
Sealing foam
installed
Advertisement
