Table of Contents
Advertisement
Protocol & Port
Protocol and Port Binding
Binding
Use these settings if you wish to ensure that particular traffic is sent by a
specific WAN port, and thereby a particular ISP account.
Protocol & Port
This list shows the details of all protocol and port configuration data which are
currently defined. You can modify them by clicking on a selected row.
Binding List
Enable - Enable or disable each item as required.
Source IP - IP address of source from which packets are sent.
Destination IP – IP address of destination to which packets are sent.
Subnet Mask – With a subnet mask other than 255.255.255.255, you can
make an IP sub-network as your destination.
Protocol – Select protocol type used by the traffic you wish to configure.
Port Range - Enter the beginning and end of the port range used by the
traffic you wish to configure. If only a single port is used, enter the port
number in both fields.
WAN - Select the WAN port you wish this traffic to use.
Page 46
Advertisement
Table of Contents
Need help?
Do you have a question about the FBR-4000 and is the answer not in the manual?
Questions and answers