Table of Contents
Advertisement
o Place the clamp (B) over the holes that match the size of the
o Carefully turn the hob back over and then gently lower it into the
o On the underneath of the hob, adjust the clamps into a position
Gas connection
Important information
o This cooker is supplied to run on natural gas only and cannot
o Conversion for use on LPG and other gases must only be
o The cooker must be installed by a qualified person, in
o Failure to install the appliance correctly could invalidate
o In the UK, CORGI registered installers are authorised to
Get user manuals:
See SafeManuals.com
screws. There are one set of screw holes in each corner of the
hob. Slightly tighten a screw (C) through the clamp (B) so that
the clamp is attached to the hob, but so that you can still adjust
the position of it.
aperture hole that you have cut out.
that is suitable for your worktop. Then fully tighten the screws
(C) to secure the hob into position.
This appliance must be installed by a competent
person in accordance with the current versions of
the following UK (United Kingdom) or ROI (Republic
of Ireland) Regulations and Safety Standards or
their European Norm Replaceme
be used on any other type of gas without modification.
undertaken by a qualified person. For information on the use of
other gases, please contact the Baumatic Technical Department.
accordance with the current edition of the Gas Safety
(Installation and Use) (Amendment) Regulations and the
relevant building/I.E.E. Regulations.
Baumatic's guarantee and lead to prosecution under the
regulations quoted above.
undertake the installation and service work, in compliance with
the above regulations.
nts.
17
Advertisement
Table of Contents
