Shutting Down The Projector; Direct Power Off - BenQ EH620 User Manual

Shutting down the projector

1. Press on the projector or
and a confirmation message will appear prompting you. If
you don't respond in a few seconds, the message will
disappear.
2. Press or
flashes orange, the projection lamp shuts down, and the
fans will continue to run for approximately 90 seconds to
cool down the projector.
3. Under windows interface, press windows start key and
click power off. (Windows > Power > Power Off)
4. Once the cooling process finishes, the power indicator becomes a steady orange and fans stop.
Disconnect the power cord from the power outlet.
• To protect the lamp, the projector will not respond to any commands during the cooling process.
• Avoid turning on the projector immediately after turning it off as excessive heat may shorten lamp life.
• Lamp life results will vary depending on environmental conditions and usage.

Direct power off

The AC power cord can be pulled out right after the projector is turned off. To protect the lamp, wait
about 10 minutes before re-starting the projector. If you attempt to re-start the projector, the fans may
run for a few minutes to cool down. In such cases, press
the fans stop and the power indicator turns orange.
54 Shutting down the projector
on the remote control
a second time. The power indicator
or again to start the projector after