Table of Contents
Advertisement
BCS-160 User Manual V1.6
11. Image Collection through PC
11.1 Configure the IP address of PC
Decompress the PC image acquisition software "serverforbcs160_v7.0. Rar" provided by our
company to obtain a folder named "serverforbcs160_v7.0". This software can only run under the
system above Windows system, You also need to install ". Net4.0" software. Please check whether
the file path "C: \ windows \ Microsoft. Net \ framework" of PC side C disk is named v4 0. If not, please
install the "Microsoft. Net. Exe" software in the "serverforbcs160_v7.0" folder first.
11.2 Configure the IP Address
11.2.1 Configure the IP address of PC
Windows XP system, Windows 7 system and windows 10 system all need to set the IP address,
subnet mask and default gateway on the PC side, and all need to be set to the following numerical
configuration:
IP address（I）： 192.168.1.200
Subnet mask（U）： 255.255.255.0
Default gateway（D）： 192.168.1.100
The IP addresses of different windows systems are set as follows:
Windows XP system：Open "Control Panel > network connection", right-click "local connection",
click "properties", double-click "Internet Protocol (TCP / IP)", set the IP address, click
OK to save, and click OK again on the properties interface to save.
Windows 7 system：Open "Control Panel > network and Internet > network and sharing center >
change adapter settings", right-click "local connection", click "properties", double-click
"Internet Protocol version 4 (TCP / IPv4)", set the IP address, click OK to save, and click
OK again on the attribute interface to save
Windows 10 system：Open "Settings > Network & Internet > network and sharing centre > change
adapter settings", right-click "Ethernet", click "properties", double-click "Internet
Protocol version 4 (TCP / IPv4)", configure the address as shown in Figure 74 below, click
OK to save, and click OK again on the property interface to save
40
Advertisement
Table of Contents
