Table of Contents
Advertisement
BCS-160 User Manual V1.6
10. Software Upgrade
This model adopts flash drive (USB) upgrading method for software upgrade. Please copy the
upgrading file into the flash drive, and insert the flash drive into the USB port at the back of machine.
Hold on pressing the START key, and then turn on the power switch, you will find the choosing
interface as follows:
*If the USB flash drive is inserted well, the display will show "USB is Ready!", otherwise it
will show "Please insert the U-Disk!".
For the upgrading file, it is not allowed to change its name and format, otherwise will cause
upgrade failure.
10.1 MAINBOARD upgrading
Under interface Figure 65, press "
then press ENTER key to start software upgrading, shown as Figure 67. If there is no software file or
file name is not correct, it will display warning messages shown as Figure 68.
Figure 65
Figure 67
" or "
" key to choose "1.MAINBOARD", and
38
Figure 66
Figure 68
Advertisement
Table of Contents
