Table of Contents
Advertisement
Note:
Stopping distance may vary depending
on the spreader-sprayer load.
Driving in Reverse
1.
Move the motion control lever to the neutral
position.
2.
To move rearward in a straight line, slowly move
both levers rearward with equal pressure.
To turn left or right, release pressure on the
motion control lever toward the desired turn
direction.
3.
To stop, position both motion control levers in
the neutral operate position.
Note:
Stopping distance may vary depending
on the spreader-sprayer load.
Adjusting the Front
Reference/Speed Control Bar
Adjust the front reference/speed control bar for
desired maximum forward speed.
1.
Stop the machine and move the motion control
levers to the neutral position.
2.
Loosen the knobs on both sides of the control
tower.
Figure 15
1. Motion control levers
2. Adjustment knob
g317115
3.
Move the bar forward to obtain the fastest speed.
Move the bar backward to obtain the slowest
speed.
4.
On both sides, tighten the knobs.
Important:
Make sure the knobs are tight so the
front reference/speed control bar does not move
during operation.
Stopping the Engine
1.
Move the motion control levers back to the
neutral position and bring the machine to a full
stop.
2.
Engage the parking brake.
3.
Place the throttle midway between the "SLOW"
and "FAST" positions.
4.
Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the
"OFF" position to stop the engine.
5.
Remove the key to prevent children or other
unauthorized persons from starting the engine.
Changing the Platform Suspension
The rubber isolators under the operator platform can
be adjusted to make the ride softer or harder. There
are three positions: front, middle, and rear.
To make the ride softer move the isolators to the front
position.
To make the ride stiffer move the isolators to the rear
position.
25
Figure 16
3. Front reference/Speed
control bar
g397869
Advertisement
Table of Contents
