Table of Contents
Advertisement
Figure 34
Rear hopper panel and spinner removed for clarity
1. Bottom hopper plate
2. Rate gate
3. Hole
4. Hopper gate crank
2.
Loosen the jam nut on the lower gate linkage
ball joint housing and release the ball joint from
the ball end.
3.
Align the rate gate and the bottom hopper plate,
by inserting pins through the .25 inch (6.4 mm)
diameter holes.
4.
Adjust lower gate linkage ball joint housing until
it lines back up with the ball and reattach the ball
joint housing to the ball.
5.
Tighten the jam nut to the ball joint housing.
6.
Remove the pins from step 3.
Rate Dial Tension Adjustment
The tension on the rate dial is adjustable. The nominal
tension is when the compression spring measures
1.12 inches (28 mm) as shown in
Rotate the nut to increase or decrease tension.
g394097
5. Lower gate linkage
6. Jam nut
7. Ball joint
Figure
35.
1. Rate dial
2. 1.12 inches (28 mm)
Spread Pattern Control Tension Adjustment
If the Spread Pattern Control (diffuser) will not stay
in the set location, increase the tension. Tighten the
nut in small increments, on the left side of the hopper
assembly, to increase the tension; to decrease the
tension, loosen the nut.
1. Diffuser knob
Spread Gate Open/Close Tension Adjustment
If the Spread Gate Open/Close linkage will not stay
in the open or closed position, adjust the tension.
36
Figure 35
3. Nut
Figure 36
2. Nut
g394297
g394319
Advertisement
Table of Contents
