Table of Contents
Advertisement
Spread Impeller Speed Control
Located on the left side of the control console (see
Figure
6).
Rotate the knob counterclockwise to start the impeller
and to increase the speed and pattern width. Rotate
the knob clockwise to decrease speed, pattern width,
and to turn the impeller off.
Stall Protection Reset:
The impeller speed control has a stall protection to
prevent over-amperage. If the impeller stops spinning,
reset it by turning the knob counterclockwise to the
"OFF" position and wait five seconds before restarting.
Spray System Switch
Located to the right of the ignition switch.
Push on the top of the switch to turn on the spray
system pump. Push the bottom of the switch to turn
the sprayer "OFF". Once the pump is turned on,
the spray pressure control knob is turned clockwise
to increase pressure and/or counter-clockwise to
release pressure (and create agitation if the pump is
on). The pressure can be read on the spray pressure
gauge (decreasing pressure from gauge will increase
agitation in the tank).
Spray Pump Foot Button
Located on the left side of the operator platform.
Press and hold the foot button to turn the sprayer
system pump to "ON". Release the foot button to turn
the sprayer system pump "OFF".
Spray Pressure Control Knob
Located on the left side of the machine.
Rotate the knob clockwise to increase pressure and
counterclockwise to decrease pressure.
The pressure will be displayed on the pressure gauge.
Once the nozzles are opened, there will be a slight
decrease in pressure (adjust accordingly).
Spray Pressure Gauge
Located above the spray pressure switch on the
control console.
Displays the spray pressure when the machine is
spraying.
Digital Display Gauge
Located on the right side of the boom manifold.
Refer to the digital display User's Manual for the
display information.
Left Nozzle Spray Lever
Located to the right of the spray pressure control.
Pull the lever rearward to turn it on. Push the lever
forward to turn off the left nozzle spray.
Center Nozzle Spray Lever
Located to the right of the left nozzle spray lever.
Pull the lever rearward to turn it on. Push the lever
forward to turn off the center nozzle spray.
Right Nozzle Spray Lever
Located to the right of the center nozzle spray lever.
Pull the lever rearward to turn it on. Push the lever
forward to turn off the right nozzle spray.
Spray Wand
Located on the right side of the tower.
Use the spray wand to spot treat small areas.
Spray Wand Trigger
Located on the bottom of the spray wand handle.
Squeeze the trigger to the handle of the spray wand
to allow spray; release the trigger to stop.
Spray Wand Trigger Lock
Located on the bottom of the spray wand handle.
Squeeze the trigger to the handle of the spray wand
to allow spray. Push the lock trigger forward to keep it
in the open flow position. Pull the lock back to release
the trigger.
Spray Wand Spray Lever
Located to the right of the right nozzle spray lever
(black lever).
Pull the lever rearward to turn on the pressurized hose
reel. Push the lever forward to turn off the hose reel.
Pulling the lever rearward to the On position allows
liquid to flow to the hose reel for spraying out of the
hand spray wand. When hose reel is not in use, be
sure to push the lever forward to the Off position to
prevent the wand tip from dripping.
Spray Pump Valving
Located below the knee pad.
The valving options allow product to be pulled from
both tanks simultaneously or independently.
14
Advertisement
Table of Contents
