Otto Bock F23 Maverick Vertical Shock Instructions For Use Manual page 21

5.1.1 Pre-compressing the functional ring
In order to achieve its full flexibility, the functional ring has to be compressed
before the first use.
1) Using the pre-compression kit, compress the functional ring for
15 minutes (see fig. 4, see fig. 5).
2) Disassemble the pre-compression kit.
5.1.2 Applying/removing the footshell
INFORMATION
► Pull the protective sock over the prosthetic foot to prevent noises in the
footshell.
► Always use the prosthetic foot with the footshell.
► Apply or remove the footshell as described in the footshell instructions
for use.
5.1.3 Bench Alignment
TT bench alignment
Required materials: 662M4 goniometer, 743S12 heel height measuring device,
743A80 50:50 gauge, alignment tool (e.g. 743L200 L.A.S.A.R. Assembly or 743A200
PROS.A. Assembly)
Assemble and align the prosthetic components in the alignment apparatus according
to the following specifications:
Dorsiflexion/plantar flexion: Adjust the prosthetic foot to the heel height of
the shoe. (The prosthetic foot is designed for shoes with a heel height of
10 mm.)
Adduction/abduction: Adjust the angle of the prosthetic socket in the front­
al plane.
Flexion/extension: Adjust the angle of the prosthetic socket in the sagittal
plane.
Linear shifting of the prosthetic socket: Shift the prosthetic socket so that
the plumb line runs along the front edge of the adapter on the prosthetic foot
(see fig. 2).
TF bench alignment
► Observe the information in the prosthetic knee joint instructions for use.
5.1.4 Static Alignment
• Ottobock recommends checking the alignment of the prosthesis using
the L.A.S.A.R. Posture and adapting it as needed.
Bench alignment process
21