Table of Contents
Advertisement
ASSEMBLY/INSTALLATION
Location
The saw must be installed on a structurally stable floor. The
coolant pump ouput and inputs may extend below the coolant
tank when the saw is at rest. Ensure that coolant flow is not
restricted throughout saw movement. The saw's rest position
may be adjusted by changing the set bolt's height.
Position the saw on a clean dry floor that has no oil or grease
stains.
Machine dimensions
The following figure shows the approximate dimensions of the
saw and its parts. When determining a final location for your saw,
ensure there is enough clearance for both the operator and for
technicians who will servise the saw. Also,consider the size of
large workpieces that may extend beyond the saw's table and
require extra space.
Working
table height
35.62"
25.20"
38.92"
Figure 1.
Dimensions
6
Lifting and setting up the saw
machines used to move this saw are properly rated to
handle the weight. The saw is heavy.
1.
NOTE: The saw is heavy, see "SPECIFICATIONS" Be certain
2.
3.
4.
73.70"
16.34"
29.53"
9.39"
Figure 2. Lifting
5.
6.
7.
Make certain that slings, cables, chains,
forklifts or other load suspending gear or
The saw must be properly secured and
anchored before use. Make sure that it is
supported equally on all four corners.
Clear the space around the machine. Leave the machine
attached to the pallet.
any machine or devises used to lift the saw are capable
of handling this weight.
Ensure sufficient space is available for operation.
Remove all the nuts and/or bolts securing saw to the pallet.
The saw can be moved using a forklift or a hoist with the
installed eye bolt, as shown in the following figure.
Carefully lift the saw off the pallet. Lift it no higher than
necessary to clear the surface on which it is to be installed
and pull the pallet out of the way. DO NOT put your hands or
feet beneath the saw while moving it or removing the pallet.
Place the saw into its final location.
Level the saw using shims under the corners needing
them. A highly accurate spirit or digital level should used for
leveling. It is very important that the saw be properly leveled
for accurate performance.
Advertisement
Table of Contents
