APS iBoard IB-R296 Quick Start Manual

Table of Contents

Download this manual

iBoard

by APS

READ INSTRUCTIONS CAREFULLY BEFORE START ING

INSTALLATION. REMOVE CONTENTS FROM BOX AND

VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS

RECOMMENDED.

*ROCKER PANEL MOUNT

*NO DRILLING REQUIRED

Driver

iBoard

Front

Customer Support: info@iboardauto.com

Fastener Size

Tightening Torque (ft-lbs)

6mm

8mm

10mm

12mm

14mm

PART#: IB-R296

Required

√

6-7

16-18

√

31-32

56-58

92-94

Passenger

Rev. 20220301

Table of Contents

Need help?

Do you have a question about the iBoard IB-R296 and is the answer not in the manual?

Page 1 ® ® iBoard by APS PART#: IB-R296 Fastener Size Tightening Torque (ft-lbs) Required READ INSTRUCTIONS CAREFULLY BEFORE START ING INSTALLATION. REMOVE CONTENTS FROM BOX AND √ VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS 16-18 √ RECOMMENDED. 10mm 31-32 12mm...
Page 2 iBoard ® Hardware Package A (For Bracket Installation) Item Description Item Description Mounting Brackets M8 Large Flat Washers M8X1.25-30mm Hex Bolts M8 Lock Washers Hardware Package B (For Step Bar Installation) Item Description Item Description M6X1-20mm Square Head Bolts M6 Nylon Lock Nuts M6 Large Flat Washers Customer Support: info@iboardauto.com Rev.
Page 3 iBoard ® STEP 1 Start installation from the driver side front of the vehicle. Locate the plastic plugs along the bottom edge of the body, (Fig 1). Remove the plastic plugs from the front mounting location. Di- rectly above each threaded insert is a top mounting location on the side of the body panel.
Page 4 iBoard ® STEP 4 STEP 5 Level and adjust the Running Board and fully tighten all hard- Once all (2) mounting brackets are installed. Select a Running ware. Board. Slip (2) M6X1-20mm Square Head Bolts into each bot- tom channel (Fig 5). Carefully position the Running Board onto Important: Please follow the recommended Tightening Tor- the (2) Mounting Brackets.