Optional Devices; Attach Handstrap (Optional); Attach The Stylus Clip (Optional); Figure 10 Mx3X With Handstrap Installed - LXE MX3X User Manual

12

Optional Devices

Attach Handstrap (Optional)

Note:
Once installed, the elastic handstrap provides a means for the user to secure the computer to their
hand. It is adjustable to fit practically any size hand and does not interfere with battery charging
when the MX3X is in a cradle.
Tool Required: #1 Phillips Screwdriver
Installation
1. Place the MX3X, with the screen facing down, on a flat stable surface.
2. Attach the handstrap to the MX3X with the screws and washers provided.
3. Test the strap's connection making sure the MX3X is securely connected to each end of the
strap connectors.

Attach the Stylus Clip (Optional)

Carefully remove the paper backing from the Stylus Clip sticky. Firmly press the sticky side of the
clip onto the mobile device and hold in place for 15 seconds. Thread the tether through the end of
the stylus and tie the ends firmly to the Stylus Clip so that the ends don't interfere with placing the
stylus in the Stylus Clip. Place the stylus in the Stylus Clip when not in use.
An extra or replacement stylus can be ordered from LXE. See the section titled Accessories for the
stylus part number.
MX3X User's Guide
These instructions are not to be used for the MX3P. See Accessories for MX3P holding
accessories e.g. holster mounted, shoulder straps, etc.

Figure 10 MX3X With Handstrap Installed

Optional Devices
E-EQ-MX3XOGWW-L