Satellite Mode; Selecting A Handset To Use The Satellite Mode; Push An Active Call To The Handset - 2N T58W Pro User Manual

Table of Contents

Yealink T58W User Guide

When DECT LED glows green/orange, the registration to the phone is successful.

Satellite Mode

You can bind a W53H/W56H/W59R handset with the VP59/T58A/T58W phone to use the satellite mode.

The phone account is applied to the handset, and all line statuses (for example, DND) on the phone and the hand-

set are synchronized. You can use the phone while you are sitting at your desk, and use the handset while away

from your desk to enhance your business activities.

The phone and the handset can share contacts. For more information, refer to

Satellite mode is available only when one handset is registered. For more information, refer to

Registration.

Note

: After the handset is bound to your phone, the assigned outgoing/incoming line(s) configured for the handset by your

administrator is disabled.

Topics

Pull an Active Call from the Handset

Selecting a Handset to Use the Satellite Mode

You can select a handset to use the satellite mode with the phone, and configure a mode for whether to continue

the conversation of the handset when the phone goes off-hook.

There are two satellite modes:

Busy: You cannot switch the active call between the phone and the handset. Regardless of the phone or the

handset, the device in a call can initiate a new call. If you are not in a call and try to initiate a call on the

phone/handset, the phone/handset screen will prompt "Path Busy".

Take over call: When the handset is during the call, you can retrieve the call from the handset to the phone after

off-hook. When the phone is during the call, you can push the call to the handset.

Procedure

1. Swipe left or right to go to the second/third idle screen.

2. Go to DECT Settings > Satellite Mode.

3. Select the desired handset.

4. Select a mode from the Select mode field.

5. Tap