Table of Contents
Advertisement
Yealink T58W User Guide
3. (Optional.) To research the available network, select
4. Tap the desired wireless network (SSID) to connect to it.
5. Enter the desired password in the Password field.
6. (Optional.) Tap
to make the password visible.
7. Select Show advanced options to configure the HTTP proxy for the Browser.
8. Select Connect.
Once the connection has completed successfully, the prompt "Connected" appears under the corresponding
SSID.
Related Topic
Activating the Wi-Fi Mode
Connecting to the Wireless Network Using Wi-Fi Protected Setup
You can connect to the wireless network by using the Wi-Fi protected setup (WPS) to make the connection easier.
The WPS provides simplified mechanisms to configure secure wireless networks. WPS can automatically configure
a wireless network with a network name (SSID) and strong WPA data encryption and authentication.
There are two supported methods in the Wi-Fi protected setup:
Push Button Configuration (PBC): The user simply has to press the WPS key on both the phone and gate-
l
way/router to connect.
Personal Identification Number (PIN): The user enters the PIN generated randomly by the phone on the gate-
l
way/router to connect.
It is not available to T58W phones.
Before You Begin
Make sure that the Wi-Fi mode is activated.
Procedure
1. Swipe left or right to go to the second idle screen.
2. Go to Settings > Basic Settings > Wi-Fi.
3. Do one of the following:
Select
> WPS to use the PBC method, then long press the WPS key on your gateway or router.
l
Once WPS setup has completed successfully, the phone screen will prompt "Connected".
Select
> WPS-PIN to use the PIN method, then log into your gateway or router's web interface, and con-
l
figure it to search the clients. For more information, refer to the documentation from the gateway or router man-
ufacturer.
Once WPS-PIN setup has completed successfully, the web interface of the gateway or router will prompt the
connection is successful.
Related Topic
Activating the Wi-Fi Mode
Adding a Wireless Network Manually
If your gateway/router has SSID broadcast disabled, it doesn't appear in the scanning results. Then you must manu-
ally add a wireless network.
Before You Begin
Get the available wireless network information from your system administrator. Make sure that the Wi-Fi mode is
activated.
162
> Scan.
Advertisement
Table of Contents
