Table of Contents
Advertisement
27. General
The ADI-2/4 Pro SE is a UAC 2.0 Class Compliant device. Mac OS X has full UAC support built-
in, there is no driver installation required. Connect computer and ADI-2/4 Pro SE with a USB
cable. Mac OS X detects the new hardware as ADI-2/4 Pro SE (serial number).
The number of available channels depends on the current Class Compliant mode: 2 channels I/O
when set to Stereo, 6 in / 8 out when set to Multi-channel. See chapter 14.1.3. Note: changing
the CC-Mode requires to temporarily disconnect the interface from the computer.
For firmware updates please see chapter 7.
27.1 Configuring the ADI-2/4 Pro SE
Configuration of the ADI-2/4 Pro SE is mostly done directly at the unit. When set to Clock Source
Internal, Mac OS X will set the current sample rate.
Via Launchpad – Other – Au-
dio MIDI Setup the ADI-2/4
Pro SE can be configured for
the system wide usage. The
Audio
window
includes
a
menu to select the sample
rate. In Stereo mode up to 768
kHz are supported, in Multi-
channel mode up to 192 kHz.
The two modes can not be se-
lected here, but have to be
chosen at the unit while it is
disconnected from the com-
puter.
Use Configure Speakers to
freely configure the stereo or
multi-channel playback to any
available channels.
Applications that don't support card or channel selection will use the device chosen as Input and
Output in the System Preferences – Sound panel. This setting is also available in the Audio
MIDI Setup via the gear symbol at the bottom of the window.
User's Guide ADI-2/4 Pro SE - v 1.0
64
Advertisement
Table of Contents
