Introduction; Notes On Operational Safety - Zeiss MCU 2008 Operating Manual

Carl Zeiss
1

INTRODUCTION

1.1

Notes on Operational Safety

MCU 2008 has been designed, produced and tested in compliance with the standard DIN EN 61010-1
(IEC 61010-1), Safety Requirements for Electrical Measuring, Control and Laboratory Instruments.
The instrument meets the requirements of the EC Directives 2006/95//EC, Low Voltage Directive, and
2004/108/EC, Electromagnetic Compatibility. It has to be disposed of in compliance with the WEEE
Directive 2002/96/EC. It is marked with the
This operating manual contains information and warnings that must be followed by the user.
The following warning and information symbols are used in this manual:
CAUTION
This symbol indicates a possible hazard to the user.
CAUTION
Disconnect power supply before any kind of intervention into the system!
CAUTION
Crush hazard!
CAUTION
This symbol indicates a possible hazard to the instrument or system.
NOTE
This symbol indicates a note that should be closely followed.
The MCU 2008 must not be used for purposes other than those described in this operating manual.
The operating instructions of the microscope used have to be observed.
4
INTRODUCTION
Notes on Operational Safety
label.
MCU 2008
M60-2-0019 e 05/2012