Table of Contents
Advertisement
Carl Zeiss
4
OPERATION
4.1
Switching on / off
Fig. 4-1
Switching on the MCU 2008 unit
4.2
Moving a Sample by means of the Optional Joystick
Don't reach into the possible range of travel of the motorized DC stage.
There is a crush hazard and hands may be injured when positioning the stage by means of the
MCU 2008 controller.
Fig. 4-2
Joystick
14
OPERATION
Switching on / off
• Use the on/off switch (4-1/1) at the front of the
unit to turn the controller ON and OFF,
respectively.
• Move the operator lever (4-2/2) of the joystick
in the direction in which the stage shall travel.
The wider the lever is displaced, the faster the
stage will travel.
• Press the switchover knob (4-2/1) integrated in
the operator level in order to change the speed
mode "slow" or "fast".
If the MCU 2008 is run in connection with the
motorized
Axio Observer, it is possible to set for each
objective separately a factor for individual adap-
tation of the speed ranges "slow" and "fast",
using the TFT display of the respective microscope
or the configuration program MTB 2004.
Please refer also to the operating manuals of the
microscope used and the MTB 2004, respectively.
microscope
Axio Imager
M60-2-0019 e 05/2012
MCU 2008
or
Advertisement
Table of Contents
