EFI Kyocera 17 Configuration And Setup page 47

Job mismatch settings
This section provides some examples of the expected behavior of various combinations of the job mismatch settings.
The mismatch settings are available in Configure, under Job Management > Job Mismatch. For more information
about the mismatch function, see Command WorkStation Help.
Workflow example 1
Assumptions:
•
Enable Job Mismatch is On.
•
Mismatch Action is set to Cancel.
•
Timeout is set to 5 minutes.
If a mismatch job occurs, the following happens:
1 An error message about the mismatch appears in Command WorkStation.
Note: The message does not appear on the printer because the job was never sent to the printer.
2 You have the timeout period (default is 5 minutes) to correct the mismatch, for example, by loading the correct
size of paper.
3 If no action is taken, after the timeout period (default is 5 minutes) the message disappears and the job is
canceled.
Note: If you look at the Job Log in Command WorkStation, the job appears as canceled.
Workflow example 2
Assumptions:
•
Enable Job Mismatch is On.
•
Mismatch Action is set to Suspend.
•
Timeout is set to 5 minutes.
If a mismatch job occurs, the following happens:
1 An error message about the mismatch appears in Command WorkStation.
Note: The message does not appear on the printer because the job was never sent to the printer.
2 You have 5 minutes (the timeout period) to correct the mismatch, for example, by loading the correct size of
paper.
3 If no action is taken, then the job is suspended after 5 minutes (the timeout period).
4 When the job is suspended, it remains in the Printing queue until the user takes action. For example, the user can
choose Print, Hold, Cancel, Delete, or can change the job properties.
Configuration and Setup
Configuring print job management settings
47