Steps To Integrate The Ps-17 Into Your Network - EFI Kyocera 17 Configuration And Setup

Figure 2: PS-17 connector panel
1
2
3
4
5
6
7
8
1 USB 2.0 ports (x2)
2 Network port (Upper RJ-45) 6 Power button
3 Display port (for monitor)
4 USB 2.0 ports (x2)

Steps to integrate the PS-17 into your network

This procedure provides an overview of the steps required to integrate the PS-17 into your network and print
environment.
Ensure all cables remain routed to prevent trip hazards and to prevent accidental disconnection or
DANGER
damage. Ensure that the cables are not compressed, pinched, or bent at a sharp angle. Damaged cables
can result in electric shock to personnel, in addition to faulty operation of the equipment.
For the power connection to the PS-17, only use the power cable provided with the PS-17. Do not use a
DANGER
power cable intended for any other electronic device. It may cause fire or electrical shock.
Use caution and correct ergonomic procedures if it is necessary to lift or move the PS-17 or connected
WARNING
equipment.
If you are concerned about the possibility of information being extracted from the PS-17 Ethernet port
CAUTION
without authorization, consider securing the Ethernet port.
The power cable included is for this product only. Do not use the power cable for any other electronic
CAUTION
device.
5 DVI port
7 Power connector
8 Power switch
Configuration and Setup
Integrating the PS-17 into your network
17