Maintaining Mx480 Fpcs - Juniper MX480 Hardware Manual

See Also

Maintaining MX480 FPCs

Purpose
Copyright © 2019, Juniper Networks, Inc.
Repeat the previous steps for any additional cables.
6.
If the component is offline (its failure indicator LED is lit), use one of the following
7.
methods to bring the it online:
To bring a DPC or an MPC online:
Press and hold the corresponding online button on the craft interface until the
green LED next to the button lights steadily, in about 5 seconds.
OK
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
To bring a PIC online:
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in an FPC2 or FPC3, use a narrow-ended tool that fits inside the opening that
leads to the button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
To bring a MIC online:
Press the MIC offline/online button until the MIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the
or correct MIC or the PIC functioning by issuing the
command.
Preventing Electrostatic Discharge Damage to an MX480 Router on page 388
Maintaining Cables That Connect to MX480 DPCs, MPCs, MICs, or PICs on page 316
The MX480 router can have up to three Flexible PIC Concentrators (FPCs) installed
horizontally in the front of the chassis. For optimum router performance, verify the
condition of the FPC.
Chapter 4: Maintaining Components
.
CLI Explorer
CLI Explorer .
.
CLI Explorer
show chassis fpc command
show chassis fpc pic-status
277