Siemens SIMATIC ET 200SP Equipment Manual page 33

Using the GSD file for PROFIBUS DP
For parameter assignment of the communications module, depending on the protocol use,
you must call the following instructions (Page 35) in GSD mode:
Freeport communication:
• Port_Config (Port configuration record - data record 57)
• Send_Config (Send configuration record - data record 59)
• Receive_Config (Receive configuration record - data record 60)
• Set_Features (Activate special function - data record 58)
3964 communication:
• Port_Config (Port configuration record - data record 57)
• P3964_Config (3964 protocol configuration - data record 61)
• Set_Features (Activate special function - data record 58)
Note
The Set_Features instruction must always be called as the last configuration instruction.
Additional information
The device manual of the communications module is supplemented by the function manual
CM PtP - Configurations for point-to-point connections
(http://support.automation.siemens.com/WW/view/en/59057093) and the STEP 7 (TIA Portal)
information system. There you will find information on the following topics:
• Operating modes
• Performance optimization
• Receive buffer
• Data flow control
• Transmission integrity
• Data transmission - protocol specific
• Programming/configuring in STEP 7 (TIA Portal)
• Module-specific instructions
• Diagnostics
Information on using the communications module in a third-party system is available in the
programming and operating manual CM PtP operation with PROFINET controller
(http://support.automation.siemens.com/WW/view/en/59062563).
To use the communications modules in a third-party system, the CPU must support
communication by means of data records.
Information on reparameterization after failure and return of the power or the
PROFINET/PROFIBUS connection is available in the FAQ with the entry ID 109783576
(https://support.industry.siemens.com/cs/ww/en/view/109783576) in the Siemens Industry
Online Support.
CM PtP communications module (6ES7137-6AA01-0BA0)
Equipment Manual, 03/2021, A5E03790792-01
Parameters/address space
4.3 Parameter setting
33