Garmin G1000 Pilot's Manual page 197

Loa ding an approach procedure using the PROC Key:
1) From the Active Flight Plan Page, press the PROC Key. The Procedures Options Menu is displayed.
2) Highlight 'SELECT APPROACH'.
3) Press the ENT Key. The APPROACH window is displayed on the 'PROC – APPROACH LOADING' Page.
4) Select an approach.
5) Press the ENT Key. The TRANSITION window is displayed.
6) Select a transition (the 'VECTORS' option assumes vectors will be received to the final course segment of the
approach and will provide navigation guidance relative to the final approach course.)
7) Press the ENT Key.
8) Highlight 'LOAD?' or 'ACTIVATE?'. 'LOAD' adds the approach to the flight plan without immediately using the
approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared
for the approach, but keeps the approach available for quick activation when needed. 'ACTIVATE' adds the
approach to the flight plan and begins navigating the approach course.
9) If the approach is not approved for GPS, a 'NOT APPROVED FOR GPS' messages is displayed with 'YES'
highlighted. Press the ENT Key to acknowledge the message. To cancel the approach, select 'NO' and press the
ENT Key.
190-00590-00 Rev. C
Destination
Airport
Available
Approaches List
Figure 5-68 Available Approaches for
Destination Airport
Garmin G1000 Pilot's Guide for the Quest Kodiak 100
GPS NAVIGATION
5-81