SetPoint
Pressing the "SET" button on the main screen, you enter in the screen shown below.
In this menu you can set the cold "Chiller" and the hot "Recovery" set point.
To change the value, highlight the set point to be changed using the arrow keys, press the Set button
to enable editing, take it to the desired value using the UP or Down buttons and press Set again to
confirm.
This screen also shows an indication of the state of activation of the functions Energy Saving and
Dynamic Set Point.
During this operation, the "Real Set" label is displayed; if the Energy Saving or the Dynamic Set
Point is active, the "Real Set" is the set point value including the variation for Energy Saving or for
dynamic set; while the set point represents the real set when the Energy Saving or the Dynamic Set
Point are not active.
An example below is shown in the pictures below.