Advantech PCA-6010 User Manual page 44

! Onboard FDC Controller
When enabled, this field allows you to connect your floppy disk drives to the
onboard floppy disk drive connector instead of a separate controller card. If you
want to use a different controller card to connect the floppy disk drives, set this
field to Disabled.
! Onboard Serial Port 1
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3", and "Dis-
abled" for the on-board serial connector.
! Onboard Serial Port 2
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3", and "Dis-
abled" for the on-board serial connector.
! UART Mode Select
This item allows you to select UART mode. The choices: "IrDA", "ASKIR", and
"Normal".
! RxD, TxD Active
This item allows you to determine the active level of the RxD and TxD serial
lines. The Choices: "Hi, Hi", "Lo, Lo", "Lo, Hi", and "Hi, Lo".
IR Transmission Delay
!
This item allows you to enable/disable IR transmission delay. The choices are
"Enabled" and "Disabled".
! UR2 Duplex Mode
This item allows you to select the IR half/full duplex function. The choices are
"Half" and "Full".
! Use IR Pins
The choices are "RxD2, TxD2" and "IR-Rx2Tx2".
PCA-6010 User Manual
Figure 3.9 Super I/O device
Figure 3.10 Super I/O device (Conn.)
34