Table of Contents
Advertisement
2.10.4
SM Bus Connector (JFP2 / SNMP)
This connector is reserved for Advantech's SNMP-1000 HTTP/SNMP Remote Sys-
tem Manager. The SNMP-1000 allows users to monitor the internal voltages, temper-
ature and fans from a remote computer through an Ethernet network.
(JFP2 / SNMP) can be connected to CN19 of SNMP-1000. Please be careful about
the pin assignments, pin 1 must be connected to pin 1 and pin 2 to pin 2 on both ends
of cable.
2.10.5
External speaker (JFP2 / SPEAKER)
(JFP2 / SPEAKER) is a 4-pin connector for an external speaker. If there is no exter-
nal speaker, the PCA-6010 provides an onboard buzzer as an alternative. To enable
the buzzer, set pins 3-4 as closed.
2.10.6
Power LED and keyboard lock connector (JFP3 /
PWR_LED&KEY LOCK)
(JFP3 / PWR_LED&KEY LOCK) is a 5-pin connector for the power on LED and Key
Lock function. Refer to Appendix B for detailed information on the pin assignments.
The Power LED cable should be connected to pin 1-3. The key lock button cable
should be connected to pin 4-5.
There are 3 modes for the power supply connection. The first is "ATX power mode",
where the system is turned on/off by a power button. The second is "AT Power
Mode", where the system is turned on/off by the switch on the power supply. The third
is another "AT Power Mode" which uses the front panel power switch. The power
LED status is indicated as per the following table:
Table 2.1: ATX Power Supply LED Status (No support for AT Power)
Power Mode
PSON1(On
Back plane)
Jumper setting
System On
System Sus-
pend
System Off
LED (ATX Power Mode)
(On/off by tentative
button)
Connect 3 pin ATX signal
cable
On
Fast flashes
Slow flashes
19
LED (AT power Mode)
LED (AT power Mode)
(On/off by switching
(On/off by front panel
power supply)
switch)
Connect 1-2 pin cable
1-2 pin closed
with switch
On
On
Fast flashes
Fast flashes
Off
Off
PCA-6010 User Manual
Advertisement
Table of Contents
