Verify Kit Version - Cypress PSoC 3 FirstTouch CY8CKIT-003 Manual

d. GNU GCC Compiler (for PSoC 5 development)
e. PSoC 3 FirstTouch Starter Kit example projects and documentation
4. Following the software installation, verify you have all hardware and drivers setup for the PSoC 3
FirstTouch Starter Kit by connecting the kit board to your PC via its USB interface. As this is the
first time you have connected this board to this PC, initial driver installations occur. Should any
on-screen dialogs appear, follow them to complete the installation process.
5. Now, verify your installation and setup by opening PSoC Programmer with the kit board attached
over USB. Open PSoC Programmer. In the port selection frame, you should see the PSoC 3
FirstTouch starter kit. If you do, you have successfully installed all required software and drivers
to begin your PSoC 3 evaluation. Congratulations!
6. Close PSoC Programmer
7. Open PSoC Creator and continue on to the next section to experiment with the included example
projects.
3.3

Verify Kit Version

To know the kit revision, look for the white sticker on the bottom left on the back side of the kit box. If
the revision reads CY8CKIT-003A Rev **, then congratulations, you own the latest version.
You can also check the silicon marketing part number on the board. If the part number is
CY8C3866AXI-040, then congratulations, you own the latest version and This kit is equipped with
production PSoC 3 silicon.
To upgrade CY8CKIT-003 to CY8CKIT-003A, you can purchase our latest kits at
go/CY8CKIT-003.
CY8CKIT-003 PSoC 3 FirstTouch Starter Kit Guide, Spec. # 001-49613 Rev. *D
Installation
www.cypress.com/
11