Table of Contents
Advertisement
WARNING:
Eliminate the risk of electric shock by removing all AC power from the system before
installing or replacing any non-hot-plug hardware option. Disconnect all power cords to
completely remove power from the server.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
IMPORTANT:
board installed.
Release the full-length expansion board retainer, and then remove the PCI riser cage.
5.
Remove the air baffle (on page 29).
6.
Remove the fan cage
7.
Disconnect any SAS cables from the hard drive cage and either the embedded SAS controller or an
8.
optional SAS controller. Do not disconnect the power cable.
It is necessary to remove the PCI riser cage only if there is a full-length expansion
("Remove the hot-plug fan
cage" on page 24).
Cabling 86
Advertisement
Table of Contents
