Table of Contents
Advertisement
WARNING:
•
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
•
times.
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed against it.
•
Pay particular attention to the plug, electrical outlet, and the point where the cord extends from
the server.
Installing the operating system
This ProLiant server does not ship with provisioning media. Everything needed to manage and install the
system software and firmware is preloaded on the server.
To operate properly, the server must have a supported operating system. For the latest information on
operating system support, see the HP website (http://www.hp.com/go/supportos).
To install an operating system on the server, use one of the following methods:
•
Intelligent Provisioning—The iLO Management Engine is a new feature on ProLiant servers that contains
Intelligent Provisioning for embedded deployment, updating, and provisioning capabilities. Intelligent
Provisioning can configure the server and install an operating system, eliminating the need for
SmartStart CDs and Smart Update Firmware DVDs.
To install an operating system on the server with Intelligent Provisioning (local or remote):
Connect the Ethernet cable, and then power on the server.
a.
During server POST, press the F10 key.
b.
Complete the initial Preferences and Registration portion of Intelligent Provisioning (on page 91).
c.
At the 1 Start screen, click the Configure and Install button.
d.
To finish the installation, follow the on-screen prompts. An Internet connection is required to update
e.
the firmware and systems software.
•
Remote deployment installation—To remotely deploy an operating system, use Insight Control server
deployment for an automated solution.
For additional system software and firmware updates, download the HP Service Pack for ProLiant from the HP
website (http://www.hp.com/go/spp/download). Software and firmware must be updated before using
the server for the first time, unless any installed software or components require an older version. For more
information, see Keeping the system current (on page 99).
The Smart Update Firmware DVD ISO is also available at the download tab on the HP website
(http://www.hp.com/go/foundation).
For more information on using these installation methods, see the HP website (http://www.hp.com/go/ilo).
Powering on and selecting boot options
Connect the Ethernet cable and press the Power On/Standby button.
1.
During the initial boot:
2.
To reduce the risk of electric shock or damage to the equipment:
Setup 37
Advertisement
Table of Contents
