Alarm Server; Event Configuration; Exception - Nuvico Xcel NCT-5MLC User Manual

Colorburst ip cameras
Table of Contents

Advertisement

Network Camera User Manual
2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. Trigger Email and FTP. The setup steps are the same as motion
detection. Please refer to

4.3.3 Alarm Server

Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the
camera will transfer the alarm event to the alarm server. If an alarm server is not needed, there
is no need to configure this section.

4.4 Event Configuration

For more accuracy, here are some recommendations for installation.
Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of
detection.
Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass,
lake surfaces and so on).
Avoid places that are narrow or have too much shadowing.
Avoid scenario where the object's color is similar to the background color.
At any time of day or night, please make sure the image of the camera is clear and with
adequate and even light, avoiding overexposure or too much darkness on both sides.

4.4.1 Exception

This function can detect changes in the surveillance environment affected by the external
motion detection
chapter for details.
22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Xcel NCT-5MLC and is the answer not in the manual?

Questions and answers

Table of Contents