Table of Contents
Advertisement
12
Set your termination switch
Use the PCI retainer brackets
DigiSuite card's
base board
DigiSuite card's
module board
Chapter 2: Installing DigiMix
DigiMix provides a DIP switch for 75 Ω blackburst termination for the
REF IN connection. This is located at the top of the base board near the
connection end of the card.
Switch 1 position
for Hi Z
Normally, you should set this switch to the position marked "75" before
installing DigiMix in your system.
Almost all computers contain card guides at the front end of the computer
chassis. These help to stabilize cards. Since PCI cards are neither long
enough nor correctly centered to use these guides, some of the PCI-based
DigiSuite cards are equipped with a PCI retainer bracket. The following
diagram depicts the retainer bracket's use:
PCI retainer
Switch 1 position for
75
termination
Switch 2 (not used)
bracket
ISA card guide
Advertisement
Table of Contents
