ISA T1000 PLUS User Manual page 15

DOC. MIE91093
All tests performed after setting the header will be grouped
together: the TDMS software will group them together, and
will allow to show test results with a single result table and
diagram. Once a relay has been tested, it is important to
change at least the relay serial number, so that results of
different relays are not mixed together. If a relay has more
than one curve, it is possible to give different headers, just by
adding a suffix letter to the serial number.
Once selected the Header, the following window is displayed.
The operation to input the header is the following.
 After having entered, if you move the knob it will move
between: arrow up; Plant name; arrow down, Return.
 If you press the arrow up or down, you will scroll
through:
Model/manuf., Feeder.
 Once you have reached the desired description, select
it and press: the description goes in reverse, and you
can edit it.
 The editor is performed as follows. If you turn the
knob, it will reach a number of selections in the bottom,
and then the line with the alphabet letters; at the end
of this, there is a double arrow, that, if pressed,
replaces letters with digits.
 The input is performed reaching for a letter with the
knob, and pressing it: the letter is copied into the
description. After the letters, you can select also: /_., .
 Commands on the bottom line are: Delete the letter
after the cursor; Delete all the description; move one
letter left; move one letter right; OK, to be pressed at
the end of the editing, before going to another
description.
 At the end of all editing, press the return arrow.
During a test, results can be memorized selecting Test
control > Save. Four selections are available:
Rev. 1.34
Plant name,
Page 15 of 145
Operator, Serial number,