Configuring Interface Parameters - Gossen MetraWatt METRAHIT PM TECH Operating Instructions Manual

9.2 Configuring Interface Parameters

irStb – status of the infrared receiver in the stand-by mode
There are two possible switching statuses for the infrared
interface when the multimeter is switched off:
IR appears at the display and the infrared interface is
ir on:
active, i.e. signals such as making commands can be
received, and power is consumed even though the
multimeter is switched off.
IR does not appear at the display and the infrared
ir oFF:
interface is switched off, signals cannot be received.
MEASURE
...
1nFo   SET
SETUP
FUNC
ir on / ir oFF

ENTER
(irstb = ir on = default setting,
irstb = ir oFF = status upon shipment)
Gossen Metrawatt GmbH
FUNC
rAtE
...
  irStb
ENTER
FUNC
ENTER
Addr – Address
If several multimeters are connected to the PC via an interface
adapter, a separate address can be assigned to each instrument.
Address number 1 should be selected for the first instrument, 2
should be assigned to the second and so forth.
MEASURE
...
1nFo   SET
SETUP
FUNC
00 ... 01 ... 15

ENTER
(15 = default setting)
Interface Operation
FUNC
rAtE ...
  Addr
ENTER
FUNC
ENTER
50