Communication Network; 5800D1 Mechatrolink-Ii - Advantech LNC-5800D Hardware Maintenance Manual

 Suggested to use the power supply with the model number selected by LNC; otherwise it is not
guaranteed to meet relevant requirements.

1.4.2 Communication network

1.4.2.1
◎
Description: Connected to MECHATROLINK-II Devices
◎
Wiring example as below
5800D1 controller (Master station)
built-in terminator
Slave station

Terminator are needed at the ends of the network.

Don't lay signal wires in the same duct or bundle with power lines.
12
5800D1 MECHATROLINK-II：
Slave station Slave station
......
Product introduction
Terminator
Last Slave station
Advantech LNC Technology Co., Ltd.
Advantech-LNC