Ecolan 2000E Tcp/Ip Configuration From Windows; Assigning The Ip Address With Bootp Lite - Kyocera FS-600 User Manual

5.7 EcoLAN 2000E TCP/IP Configuration from Windows

In addition to the Windows TCP/IP configuration described in the LPR Printing and
Peer to Peer Printing sections earlier in this chapter, the EcoLAN 2000E must be given
IP address and routing information to be used with TCP/IP. The IP address
information may be setup by several methods, which are listed below. The best
method for you depends upon your existing network configuration as well as your own
experience and preferences.
1) With the Printer Front Panel. If you have access to the printer, TCP/IP and other
parameters may be set using the printer front panel. See Section 8.1
8.1 Front Panel Setup
2) With Dynamic Host Configuration Protocol (DHCP). If your network is using a
DHCP server to assign IP addresses, this will most likely be the preferred method for
assigning an IP address to the 2000E. Refer to the DHCP section for more
information.
8.2 DHCP
3) With the Management Access Program (MAP). If the Windows workstation has the
IPX protocol running, then using MAP is a good choice for assigning the 2000E IP
address. Follow the MAP instructions in Chapter 3.
3.1 MAP
4) With the Bootp Lite utility. If the Windows workstation has the IP protocol running,
then Bootp Lite may be used for assigning the 2000E IP address. Bootp Lite
instructions are in the following section.
5) With the command line utility ARP. If the Windows workstation has the IP protocol
running, then ARP utility may be used for assigning the 2000E IP address. ARP
instructions are in section 5.7.2.
5.7.2 ARP

5.7.1 Assigning the IP Address with BOOTP Lite

Prior to running the Bootp Lite utility, obtain an EcoLAN 2000E Network Status Page
from your printer. The status page may be printed on demand by pressing the Status
key on the front panel of the printer. Check the network status page to be sure that
TCP/IP is enabled, and that an IP address has not already been assigned. Information
from the status page will be needed during the Bootp Lite setup procedure.
Windows Configuration 5-18