Installing The Ecolan 2000E On Multiple File Servers - Kyocera FS-600 User Manual

2. Select the printer from the Defined Printers list. The screen appears (which is
blank for an initial installation). Press INS to view a list of Notify Candidates.
3. Select the user or group from the list.
4. Set the First and Next intervals in the Notify Intervals screen. It is recommended
that you use the defaults. The First interval is the number of seconds the network
waits before it notifies candidates about a print job problem. The Next interval
specifies how often in seconds candidates are notified. Enter a number for each
interval and press ENTER.
5. Press the ESC key and then choose Save Changes. Press the ESC key at each
screen until you reach the Print Server Configuration menu. If you have finished
the configuration, press the ESC key and then save the changes.

4.1.7 Installing the EcoLAN 2000E on Multiple File Servers

To install the EcoLAN 2000E on more than one file server, perform the procedures
described in Sections 4.1.1 through 4.1.6 for each file server. You must use the same
name and password for the print server (or no password) on all file servers. You set the
password for the EcoLAN 2000E using the MAP program (refer to 4.3 Configuring
the EcoLAN 2000E in NetWare Directory Services ). If you use a password, specify it
on each file server using the Change Password option on the Print Server Information
menu of the PCONSOLE utility.
NetWare Configuration 4-7