Table of Contents
Advertisement
To exchange the screws
Spring screws (2) for QR SDH
Adapter screws supplied with this
unit (2)
1
If the QR-SDH is already mounted on
this unit, remove it.
2
Remove the two spring screws by
pulling up while rotating.
Save the removed spring screws for later use.
3
Screw the two adapter screws supplied
with this unit into the QR-SDH.
4
Mount the QR-SDH on this unit.
To fit the WRR-862 (when using a BP-
GL65/GL95/L60S/L80S Battery Pack)
1
Attach the WRR tuner fitting (not
supplied; service part number: A-8278-
057-B) to the back of the camcorder.
1 Use a Phillips type screwdriver to
tighten the four screws placed in the
tuner fitting. For three of these screws,
insert the screwdriver through the
corresponding hole and tighten the
screw.
Note
Make sure that all four screws are fully tightened.
QR-SDH
2 Loosen the adjustment screws on the
tuner fitting.
3 Adjust the tuner fitting position for a
BP-GL65/GL95/L60S/L80S Battery
Pack to be attached, and tighten the
adjustment screws to fix its position.
4 Attach the mount plate supplied with
the WRR-862.
About the WRR tuner fitting (service part
number: A-8278-057-B), contact a Sony
service or sales representative.
BP-GL65/GL95/L60S/L80S
Adjustment
screws
2
Attach the battery pack.
On how to attach the battery pack, see "To
attach the battery pack" on page 26.
3
Mount the tuner on the WRR tuner
fitting.
4
Connect the tuner power cord to the DC
OUT connector of the camcorder, and
the audio output cable to the AUDIO IN
CH1 or CH2 connector.
5
Set the switches as follows.
• Set the LINE / AES/EBU / MIC switch for
the channel to which the audio output cable
Preparing the Audio Input System
Mount plate
(supplied with
WRR-862)
Phillips type
screwdriver
WRR-862
37
Advertisement
Table of Contents
