Connecting The Remote Control Unit - Sony HDW-800P Manual

Connecting the Remote
Control Unit
Connecting the RM-B150/B750 Remote Control
Unit enables remote control of the principal
camera functions.
Connecting the remote control unit to the
REMOTE connector (8-pin) automatically puts
the camcorder into remote control mode. If you
disconnect the remote control unit, the remote
control mode is cancelled.
1RM-B150/B750
2Remote control cable
3REMOTE connector
Camcorder switch functions when the
remote control unit is connected
The following switches on the camcorder do not
function.
• GAIN selector
• OUTPUT/DCC switch
• WHITE BAL switch
• AUTO W/B BAL switch
• SHUTTER selector
• ASSIGN 1/3/4/5 switches and RET button on
the lens to which the TURBO SWITCH
function is assigned
• REC START button (and the recording start/
stop buttons on the lens, and the ASSIGN 1/3/4/
5 switches and RET button on the lens to which
the recording start/stop function is assigned)
(when the RM REC START item on the CAM
42

Connecting the Remote Control Unit

1
2
3
CONFIG 2 page of the MAINTENANCE menu
is set to RM)
• ASSIGN 1/3/4/5 switches and RET button on
the lens to which the electrical CC filter
function is assigned.
Paint adjustment when the remote
control unit is connected
The settings of the paint adjustment that were in
effect the last time the remote control unit was
used are recalled.
Function of the recording start/stop
buttons when the remote control unit is
connected
When the remote control unit is connected, you
can make a setting to determine which of the
recording start/stop buttons you will use. This
setting is made using the RM REC START item
on the CAM CONFIG 2 page of the
MAINTENANCE menu.
Relationship between the setting of the RM REC
START item and the function of recording start/
stop buttons
Recording start/ Settings of RM REC START
stop button
RM
Camcorder's REC Disabled
START button
Lens' VTR button Disabled
Camcorder's Disabled
ASSIGN 1/3/4/5
switches and lens'
RET button
assigned the
recording start/
stop function
Remote control Enabled
unit's VTR button
When the monitor is connected to the
MONITOR OUT connector of the remote
control unit
The MONITOR connector (BNC type) of the
RM-B150/B750 outputs the same signal as that
from the TEST OUT connector on the camcorder.
Use the black cable supplied with the RM-B150/
B750 to connect the monitor to the MONITOR
connector on the RM-B150/B750.
CAM PARA
Enabled Enabled
Enabled Enabled
Enabled Enabled
Disabled Enabled