Sony HDW-800P Manual page 107

No. Page Item
17 GENLOCK GENLOCK
GL HD H PHASE
GL SD H PHASE
REFERENCE
18 ND COMP ND OFFSET ADJUST OFF/ON
CLEAR ND OFFSET
19 AUTO AUTO BLK
SHADING SHADING
RESET BLK SHD
TEST OUT SELECT
MASTER GAIN(TMP) –6dB/–3dB/0dB/
20 APR APR
APR(SLS)
APR PRESET
21 VANC RX UMID LINE 1
UMID LINE 2
a) The setting of this item is overridden by the setting of
Other BEFORE END when TYPE DETECTION in
the BATTERY 2 page is set to OTHER.
b) The setting of this item is overridden by the setting of
Other END when TYPE DETECTION in the
BATTERY 2 page is set to OTHER.
c) When TYPE DETECTION in the BATTERY 2 page
is set to AUTO, any batteries other than Sony BP-
series batteries and Anton Bauer intelligent battery
systems are classified as Others.
Settings Description
OFF/ON Turns genlock on and off.
(–99 to 99) Sets the H phase of HD signal output during
genlock operation.
(–99 to 99) Sets the H phase of SD signal output during
genlock operation.
INTERNAL/ Displays the type of reference signal used by
GENLOCK this unit.
Turns on and off the mode which sets ND
(neutral density) filter color compensation
values.
EXEC Clears ND filter color compensation values.
EXEC Execute the auto black shading correction
function.
EXEC Clears black shading compensation values.
VBS/Y/R/G/B Selects the signal output of the TEST OUT
connector.
Temporarily sets the master gain value.
3dB/6dB/9dB/
12dB/18dB/
24dB/30dB/
36dB/42dB
EXEC Executes the automatic pixel noise reduction
function.
EXEC Suppresses white flecks in SLS (Slow Speed
Shutter) mode by executing the automatic
pixel noise reduction function.
Note
The execution time for this function is about
30 minutes. More time may be required when
temperatures inside the unit are low.
EXEC Deletes data that was registered by execution
of the automatic pixel noise reduction and
black balance adjustment functions.
0 to 20 Selects the line on which the UMID is to be
recorded (First field). When 0 is selected, the
UMID is not recorded.
0, 564 to 593 Selects the line on which the UMID is to be
recorded (Second field). When 0 is selected,
the UMID is not recorded.
d) Flashes once per second when the battery status is
BEFORE END, and flashes 4 times per second when
the battery status is END.
e) A setting for this item is enabled when the DWR-
S01D Digital Wireless Receiver is installed.
f) Delay is applied only when the timecode is locked to
an external timecode and its format is PsF.
g) HD SDI OUT in the OUTPUT 1 page of the
OPERATION menu must be set to HDSDI.
Menu List 107