Operating And Connectors Section - Sony HDW-800P Manual

Operating and connectors section

Front
1
2
a REC START (recording start) button
Press to start recording. Press it again to stop
recording. The effect is the same as that of the
REC button on the lens.
b SHUTTER selector
Set to ON to use the electronic shutter. Flick to
SELECT to switch the shutter speed or shutter
mode setting within the range previously set with
the menu. When this switch is operated, the new
setting appears on the setting change/adjustment
progress message display area for about three
seconds.
For details about the shutter speed and shutter mode
settings, see "Setting the Electronic Shutter" on
page 47.
c FILTER selector
Selects from the filters built into this unit.
10 Locations and Functions of Parts and Controls
FILTER selector (outer knob) setting and
Electrical CC (color conversion) filter
selection
FILTER selector
(outer knob) setting
A
B
C
D
a) A type of special effect filter that creates a cross of
light in the highlight section.
FILTER selector (inner knob) setting and ND
3
filter selection
FILTER selector
(inner knob) setting
1
4
2
5
3
6
4
7
When this selector is used with the menu item for
filter selection display set to ON (see page 125),
the new setting appears on the viewfinder screen
for about three seconds.
For details, see "Adjusting the white balance" on
page 45.
d MENU knob
Changes the page selection or a setting within the
menu.
For details about how to use the MENU knob, see
"Menu Operations" on page 113.
e EARPHONE jack (monaural,
minijack)
You can monitor the E-E
recording and playback sound during playback.
When an alarm is indicated, you can hear the
alarm sound through the earphone. You can use
this with the EARPHONE jack on the rear of the
unit at the same time. Plugging an earphone into
the jack automatically cuts off the built-in
speaker.
1) E-E: Abbreviation of "Electric-to-Electric". In E-E
mode, video and audio signals input to the camcorder
are output after passing through internal electric
circuits only. This can be used to check input signals.
CC filter selection
a)
Cross filter
3200K
4300K
6300K
ND filter selection
Clear
1
/ ND
4
1
/ ND
16
1
/ ND
64
1)
sound during