Slpp - Set Lines Per Page - Kyocera KM-1500 Command Reference Manual

PRESCRIBE Command Reference
SLPP —
Set Lines Per Page
Format
Parameter
number:
Function
File
306
SLPP number;
number of lines per page
The SLPP command sets the bottom margin for an exact number of lines per page based
on the current line spacing. As long as you do not change the line spacing or use
PRESCRIBE commands that move the cursor, you will get the specified number of lines
per page.
To control the page size in terms of inches or centimeters instead of a number of lines,
use the SBM (Set Bottom Margin) or SPL (Set Page Length) command. The advantage
of the SLPP command is that it sets the bottom margin to accommodate an exact number
of lines, so no excess is carried over to the next page.
A bottom margin setting in a document file should be placed at the beginning of the file
or at a page break.
!R! RES; UNIT C;
SFNT "TimesNewRoman";
STM 1; SLS 1; SLPP 10;
EXIT, E;
Top margin at 1 cm, with 10 lines per page. (Line 1)
Line 2
Line 3
Line 4
Line 5
Line 6
Line 7
Line 8
Line 9
Line 10
Line 11
Line 12
!R! PAGE; EXIT;