Dap - Draw To Absolute Position - Kyocera KM-1500 Command Reference Manual

PRESCRIBE Command Reference
DAP —
Draw to Absolute Position
Format
Parameters
x-coordinate:
y-coordinate:
Function
File
72
DAP x-coordinate, y-coordinate;
distance from the left margin
distance from the top margin
The DAP command draws a line from the current cursor position to a position specified
relative to the top and left margins. The thickness of the line is designated by the SPD
(set pen diameter) command. The coordinates and line thickness are measured in the
units designated by the UNIT command.
The coordinates may be positive or negative. Negative coordinates cause the line to
extend outside the margin.
The DAP command is ignored in the path mode graphics.
!R! RES;
UNIT C;
CMNT Tree Diagram;
STM 8; SLM 8;
MAP 0, 0; DAP 2, 0.5;
MAP 0, 1; DAP 2, 0.5;
MAP 0, 1; DAP 2, 1.5;
MAP 0, 2; DAP 2, 1.5;
MAP 0, 2; DAP 2, 2.5;
MAP 0, 3; DAP 2, 2.5;
MAP 2, 0.5; DAP 4, 1;
MAP 2, 1.5; DAP 4, 1;
MAP 2, 1.5; DAP 4, 2;
MAP 2, 2.5; DAP 4, 2;
MAP 4, 1; DAP 6, 1.5;
MAP 4, 2; DAP 6, 1.5;
PAGE; EXIT;