Pie - Draw Pie Chart - Kyocera KM-1500 Command Reference Manual

PIE —
draw PIE chart
Format
Parameters
radius:
starting-angle:
slice-size:
Function
File
PIE radius, starting-angle, slice-size, ...;
radius of the pie chart
position of the first slice
relative sizes of the slices
The PIE command is a standard mode graphics command which draws a pie chart
centered at the current cursor position. The sizes of the slices may be specified using any
convenient non-negative integers. (PIE commands are ignored if they contain negative
slices, or slices with decimal fractions.) The sum of the slice sizes should not exceed
9999. The total length of the command must not exceed 255 characters.
The printer automatically converts the slice sizes to angles totaling 360 degrees. It draws
the first slice starting at the position specified by the second parameter (0 = vertically
up), then draws the other slices in order, proceeding in a clockwise movement. The line
thickness is designated by the SPD command.
!R! RES; UNIT C;
MZP 10, 10;
PIE 3, 0, 10, 20, 30, 40;
PAGE;
EXIT;
PIE
197