Kobalt KID 124B-03 Manual page 47

OPERATING INSTRUCTIONS
5. LED Work Light
The LED work light (F), located on the base of the
drill/driver, will illuminate when the trigger switch (E)
is depressed. This provides additional light on the
surface of the work piece for operation in lower-light
areas.
The LED work light will turn off within approximately
10 seconds after the variable-speed trigger switch
is released.
a. The LED work light will flash rapidly if the tool
has stopped automatically when the tool and/
or battery pack became overloaded or too hot.
Please wait for the tool and/or battery pack
to cool down, at which point it can be started
again.
b. The LED work light will flash slowly to indicate that the battery charge is very low. Please
recharge the battery pack.
6. Keyless Chuck
The drill/driver features a keyless chuck (A) to
tighten or release drill bits in the chuck jaws
without using an additional tool. The arrows on the
chuck indicate the direction in which to rotate the
chuck body in order to "GRIP" (tighten) or "OPEN"
(loosen) the chuck jaws on the drill bit.
5
F
6
A
A
11
Tighten
Loosen