Preparation - Kobalt KID 124B-03 Manual

SAFETY INFORMATION
Drill Safety Warnings
Safety Instructions for All Operations:
• Use the auxiliary handle(s). Loss of control can cause personal injury.
• Hold the power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory or fasteners may contact hidden wiring. Cutting accessory
or fasteners contacting a "live" wire may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Safety Instructions When Using Long Drill Bits:
• Never operate at higher speed than the maximum speed rating of the drill bit. At higher
speeds, the bit is likely to bend if allowed to rotate freely without contacting the workpiece,
resulting in personal injury.
• Always start drilling at low speed and with the bit tip in contact with the workpiece.
At higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
• Apply pressure only in direct line with the bit and do not apply excessive pressure.
Bits can bend causing breakage or loss of control, resulting in personal injury.
Additional Warnings
• Use only with the battery packs and chargers listed below:
BATTERY PACK
KB 224-03; KB 424-03; KB 524-03;
KB 624-03; KXB 424-03; KXB 824-03

PREPARATION

Know Your Drill/Driver
Before attempting to use the drill/driver, familiarize yourself with all of its operating features and
safety requirements.
Helpful tool (not included): Phillips-head screwdriver.
WARNING
• Do not allow familiarity with the drill/driver to cause carelessness. Remember that one
careless moment is enough to cause severe injury. Before attempting to use any tool, be
sure to become familiar with all of the operating features and safety instructions.
• Do not attempt to modify this tool or create accessories not recommended for use with this
tool. Any such alteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
CHARGER
KRC 2445-03; KRC 2490-03;
KRC 2404-03; KDPC 124-03;
KCH 2401-03; KCH 2411-03
8