Operating Instructions - Kobalt KID 124B-03 Manual

OPERATING INSTRUCTIONS

1. To Charge a Battery Pack
NOTICE: Battery packs are
shipped in a low charge
condition to prevent possible
problems. Before using it the
first time, fully charge the
battery pack.
a. Make sure that the battery
pack is compatible with
this charger.
b. Connect the charger to
a power supply. The red
and green LED charge indicators (B) and (C) will illuminate for
approximately 1 second and then turn off.
c. Attach the battery pack to the charger by aligning the raised ribs
of the battery pack with the slot in the charger. Slide the battery
pack onto the charger (Fig. 1).
d. The charger will communicate with the battery pack's circuitry
to evaluate the condition of the battery pack. Please refer to the
"Charger Display" section.
e. The green LED (B) will flash continuously during normal
charging.
f. After charging is complete, the green LED (B) on the charger will
be continuously on and the power indicator LEDs on the battery
pack will turn off. The power indicator LEDs on the battery pack
will illuminate when the power indicator button is pressed when
the battery pack is detached from the charger.
NOTICE:
• When the battery pack is fully charge disconnect it form the charger.
• The charger may get warm with several continuous charge
cycles. This is part of the normal operation of the charger.
1
B
C
11