Installing The Ac Power Supply In An Ssr1300 - Juniper SSR1300 Hardware Manual

7. Place one hand under the power supply to support it and slide it completely out of the chassis. Take
care not to touch power supply components, pins, leads, or solder connections.
Figure 19: Remove an SSR1300 AC Power Supply
8. Place the power supply in the antistatic bag or on the antistatic mat placed on a flat, stable surface.

Installing the AC Power Supply in an SSR1300

To install an AC power supply (see
1. Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the
chassis.
2. If the power supply slot has a cover panel on it, remove the cover panel. Save the cover panel for
later use.
3. Taking care not to touch power supply pins, leads, or solder connections, remove the power supply
from the bag.
Figure 20 on page 50):
49