Table of Contents
Advertisement
MIDI Features and Controls
Changing the MIDI Channel
From the factory the Revelation is set to receive Midi messages on Midi channel 1, however this
can be changed upon powering up the pedal. After applying power to the Revelation, hold down
the Preset switch while the pedal is in startup mode (Mix & Decay knobs are white and the Bypass
and Preset LED's are flashing). While continuing to hold down on the Preset switch, the Bypass LED
will flash the number of times equivalent to the Midi channel (set to 1 from the factory) and then
will have a 2 second pause before flashing again. Simply press the Bypass switch to increment the
Midi channel by 1, press as many times necessary to change to the correct Midi number. The
numbers available on the Revelation are channels 1 thru 16, once you've reached number 16 the
next press will start over again at number 1. Once you have the right number selected, just
release the Preset switch to save this setting into permanent memory.
Advertisement
Table of Contents
