Jet Revelation Reverb V2.0 Manual page 7

Table of Contents

Advertisement

LED will turn on and all the knobs will be locked/inactive. To exit Preset Mode, just press the preset
switch again and all knobs will be back to Live Mode.
Our soft click Bypass and Preset switches are smart switches which have several different timed
based functions to control various features of the pedal. Since there is a lot of time based magic 
happening behind the scenes, please note that it is possible to rapidly press the switch so fast that
it will not recognize the press. A good solid press should be sufficient to engage the Bypass or
Preset switch.
Time based functions are as follows:
To switch algorithms on the fly, press and hold the Bypass switch for at least 3/4's of a
second and upon releasing the Bypass switch you will cycle through to the next algorithm.
To switch presets on the fly, press and release both of the Bypass and Preset switches at the
same time. This will cycle through each preset until it reaches the end and then will cycle
back to the beginning. You can cycle through your presets in any state that the pedal is in
(off, on, or in preset mode). Do not press and hold both switches for longer than 2 seconds
as this will enter "Preset Save Mode".
To engage infinite Bloom, press and continue to hold the Preset switch, as long as the switch
is being held down the Preset LED will begin to flash and the Decay knob will gracefully
increase until it reaches its maximum setting. Once the Preset switch is released the Preset
LED will continue to flash letting you know the Decay knob is gracefully returning to its
original setting. 
When switching between modes (Live or Preset) and you are transitioning from a long decay
to a shorter decay, the pedal automatically enters into a "graceful transition" state, the
Preset LED will begin to flash letting you know that the Decay knob is gracefully returning to
its new setting. Please note that whenever the Preset LED is flashing, both Bypass and
Preset switches will be inactive until the Decay knob has settled to its new position.

Advertisement

Table of Contents
loading

Table of Contents