Communications Settings - Valeport VA500 Operating Manual

4.5 Communications Settings

The full-scale DAC range is set in metres regardless of the units programmed by setting #021
# code Followed By:
#059 ;baud_rate<CR>
RS485 is enabled by grounding a pin in the communications lead -
see Wiring Information
#001 ;ALTIMETER_address<CR>
#002 <CR>
#005 ;ON<CR> or ;OFF<CR>
#006 <CR>
Analogue Settings:
#094 ;analogue_range<CR>
#095 <CR>
#096 ;counts<CR>
#097 ;Analogue range limit<CR>
#098 <CR>
Page | 11
VA500 Altimeter Operating Manual
MANUAL-1969127270-2 | issue: 1.3
Operation
Sets the units baud rate
2400,4800,9600,19200,38400,
57600,115200
Sets the 485 address
Returns the address
Turns ON or OFF address mode
Returns ON or OFF for address mode
Sets the analogue output voltage range
0 – 0 – 5V
1 – 0 – 10V
Reads analogue output voltage range
set above
Analogue output test.
Sets the range equivalent to full scale
DAC output
Reads the range equivalent to full scale
DAC output
© 2022 – Valeport Ltd